carta responsiva de compraventa de auto pdf

The dimensions shall allow for standard 19' EIA rack mounting.

The front panel controls shall consist of independent level controls for left and right channels, a master power switch and a sequential operation switch. Used Carver HTR 880 Home Theater Receiver: $99.99. Carver Amplifier and Carver Audio Product Specs. Should you be considering purchasing this particular receiver. Buy Onkyo TX-SR707 7.2-Channel A/V Surround Home. Find best value and selection for your Carver HtR 880 Home Theater Receiver search on eBay. New Replaced Onkyo Remote Control For A/V Receiver. Home Audio & Theater Premium Audio Headphones Home Theater. Total harmonic distortion shall be less that 0.5% and inter modulation distortion shall be less than 0.1%.īuy Replacement Remote Control for CARVER. Noise shall be at least 115dB below 40Vrms, A-Weighted, from 20Hz to 20kHz. The amplifier shall have a voltage gain of 28.5dB. Optional signal processing shall be available to be installed at the rear of the amplifier. The amplifier shall have slow start up and muted inputs of turn-on. A delayed send voltage of 11Vdc shall be provided at the send terminals to turn subsequent amplifiers with this feature. The amplifier shall be capable of sequential turn-on/off and remote turn-on/off with a DC voltage between +5 and +15Vdc at the receive terminals. A protection LED indicator shall activate and the amplifier shall shut down to protect against short circuits and excessive high frequencies at the outputs, DC offset present at the outputs, or an internal power supply fault. This thermal protection system shall be self-resetting. The amplifier shall have a thermal shutdown system to protect the power devices from over-temperature operation.

The amplifier shall be capable of bridge-mode operation thereby providing 700W RMS output into 8 ohms and supplying a 70-volt distribution system without output matching transformers. 8-ohm FTC rated power/ch 200W 4-ohm FTC rated power/ch 300W Bridged mono power 700W 4/8-ohm FTC rated THD 0.5% IM Distortion less than 0.1% Input Impedance (Line) 15k ohm Input Sensitivity 1.5Vrms Gain 28.5dB Rated full power bandwidth +0, -3dB at 5Hz & 80kHz Slew Rate 25V/u sec Power Consumption 950 Watts Fusing 8 amp slo-blo Damping 200 at 1kHz Dimensions (HxWxD inches) 3.5' x 19' x 11.56' Architect's and Engineer's Specifications The power amplifier being of two channels, shall deliver 200W into 8 ohms with both channels operating, or 300W into 4 ohms with both channels operating.

Carta responsiva de compraventa de auto pdf